Summary
This short blog follows on from the previous blog listing some drawings for lids/plates that were replaced with circuit boards.
 |
| Hammond 1455N1601 with Press Fit Panel |
Circuit Boards Lids
While the previous blog used a clearance of at least 0.1 mm per edge, some of the new lids used an interference fit. Board dimensions should be validated to suit each design.
Again for verification, the Altium Designer files were saved as STEP files,
converted to STL files then 3D printed before manufactured.
The DXF files below were generated using the Export feature in Altium Designer. The listed DXF
files can be imported into an Altium PCB project using measurements in
millimetres.
 |
| PCB Lid DXF for NUB505017 |
